SATO S84 ex - Page 139

4 Operation and Configuration
137
S84-ex/S86-ex Operator Manual
CALENDAR REPRINT
Perform the calendar reprint setting.
• YES: The updated calendar data (date and time) according to the RTC
(Real Time Clock) is included in the reprint data.
• NO: Print exactly the same data as before.
Note
Shows only if EXTERNAL REPRINT is set to ENABLE, REPRINT W/
FEED is set to YES, FUNCTION KEY is set to REPRINT, or
CONTINUOUS PRINT is set to ENABLE.
FORWARD/BACKFEED DISTANCE
Set the feed length in the forward and backward directions.
• DEFAULT: Enable the product to operate using the fixed value
maintained in the product.
• 000mm: Set the feed length to enable the product to operate using this
distance. The setting range of forward/backward feed length is from
001 mm to 255 mm (0.04” to 10”).
The actual forward/backward feed length is equivalent to the offset
adjustment value + the paper feed length.
Note
• If using thermal transfer for printing, set the feed distance to less than
30 mm (1.2”) to avoid detection of the ribbon end by mistake.
• If the value is larger than the distance between the print head and the
option stop position, the media may shift away from the platen during
backward feed.
EXT 9PIN SELECT
Set the output mode of the external signal pin 9 when using a 14-pin
connector (pin 6 when using a 25-pin connector).
• MODE1: Outputs the signal whether if the product has remaining print
data or not.
• MODE2: Outputs the signal whether if the product is in online or offline
mode.
• MODE3: Enable both ONLINE and PRN READY concurrently.
ONLINE pin: Outputs the signal whether if the product is in online or
offline mode.
PRN READY pin: Outputs the signal whether if the product has
remaining print data or not.
Note
Refer to the Timing Chart of the EXT Output Signal (Online) for details.
)25:$5'%$&.)(('
'()$8/7 PP
',67$1&(
02'(