SATO S84 ex - Page 140

4 Operation and Configuration
138
S84-ex/S86-ex Operator Manual
PRN READY TYPE
Set the output type of the external signal PRN READY pin.
• DATA READY: Outputs status signal on the printable state.
• DATA PRESENT: Outputs status signal on print data present in
product.
Note
Shows only if EXT 9PIN SELECT is set to MODE3.
PREND TYPE 3/4
Select whether to reflect the label feed/stop timing on PREND output
signal in External signal TYPE 3, 4.
• NORMAL: Do not reflect the label feed/stop timing on PREND output.
• MOTION: Reflect the label feed/stop timing on PREND output.
Note
Shows only if you have installed the optional RFID kit and enabled the
RFID mode.
BACKFEED SPEED
Specify the backfeed speed.
• FAST: Set to a speed of six inches per second.
• NORMAL: Set to a speed of four inches per second.
'$7$5($'<
'$7$35(6(17
3515($'<7<3(
Print
Print End (PREND)
PVHF
PWP writing
Print complete
Label feeding
Label feeding
Pause
TYPE1
TYPE2
TYPE3
TYPE4
Print Start
Print
Print End (PREND)
PVHF
PWP writing
Print complete
Label feeding
Label feeding
Pause
TYPE1
TYPE2
TYPE3
TYPE4
Print Start