2 Installing the Product
37
S84-ex/S86-ex Operator Manual
2.7
Installing Optional Memory Storage
The optional SD card or USB memory can be used for uploading and downloading data (print format,
graphics and extended characters) registered in the product and firmware.
Contact your SATO reseller or service center for the recommended SD card or USB memory.
CAUTION
Be sure to perform a virus check on the USB memory or SD card before connecting it to the product. SATO
Corporation shall not be held responsible for any product malfunctions caused by a virus spread via USB
memory or SD card.
2.7.1
Installing the Optional SD Card
You can install an optional SD card into the SD card slot located on the rear of the product.
When using the SD card for the first time, format the SD card in the memory card mode. Refer to
Section 4.2.11 Memory Mode for details.
1 Power off the product.
2 Insert the optional SD card into the SD
card slot with the orientation the same
as shown in the picture.
Contact your SATO reseller for the recommended
SD card.
3 To seat the SD card in the SD CARD slot,
push it in until it makes a slight clicking
sound and is almost completely inside the
product.
When seated and ready to operate, only a very
small portion protrudes, approximately 3.18 mm
(0.125”).
To Next Page
Loading...
