9 Appendix
359
S84-ex/S86-ex Operator Manual
9.9.4
Ribbon Specification for the Ribbon Saver
• Be sure to remove the used ribbon at the rewinder side and replace the paper core with a new one
when using up one roll of ribbon.
• Be sure to perform the preliminary operation check because the lengths of ribbon mentioned above
are calculated from mechanical structure and have a limitation according to the type of ribbon,
operating environment and usage.
9.9.5
Label Specification for the Ribbon Saver
Ribbon width 39.5 mm or more
Ribbon length Guaranteed operation speed of ribbon saver
Up to 300 m roll
(Under 69 mm in diameter)
2 to 12 inches (more than 15 mm of printing)
Up to 500 m roll
(Under 82 mm in diameter)
2 to 12 inches (more than 20 mm of printing)
Up to 600 m roll
(Under 108 mm in diameter)
2 to 6 inches (more than 30 mm of printing)
Label width 30 mm or more
Label pitch Backfeed 25 mm or more
No backfeed 60 mm or more
To Next Page
Loading...
