SATO S84 ex - Interface Mode

9 Appendix
320
S84-ex/S86-ex Operator Manual
9.1.3 Interface Mode
NOTICE FUNCTION DISABLE Yes Yes
CLEAN PRINTER NOTICE DISTANCE 0 m Yes Yes
CHANGE ROLLER NOTICE DISTANCE 0 km Yes Yes
CHANGE HEAD NOTICE DISTANCE 0 km Yes Yes
CHANGE TIMING BELT (GEAR BOX) 0 km Yes Yes
CHANGE TIMING BELT (RIBBON) 0 km Yes Yes
Setting Item Initial Value
Default
(User)
Default
(Shipping)
INTERFACE AUTO SELECT DISABLE Yes Yes
INTERFACE SETTING NO - -
PORT SELECT DATA PORT Yes Yes
DATA PORT USB Yes Yes
SUB PORT NONE Yes Yes
LAN
DHCP SETTING DISABLE Yes No
IPv4 ADDRESS 192.168.001.001 Yes No
IPv4 SUBNET MASK 255.255.255.000 Yes No
IPv4 GATEWAY ADR 0.0.0.0 Yes No
IPv6 RESOLUTION AUTO Yes No
IPv6 ADDRESS 0000:0000:0000:0000:
0000:0000:0000:0000
Yes No
PREFIX LENGTH 64 Yes No
DEFAULT ROUTER 0000:0000:0000:0000:
0000:0000:0000:0000
Yes No
PORT NUMBER1 1024 Yes No
PORT NUMBER2 1025 Yes No
PORT NUMBER3 9100 Yes No
PROTOCOL STATUS5 Yes Yes
ITEM NO. CHECK DISABLE (When STATUS5 is selected) Yes Yes
BCC CHECK DISABLE (When STATUS5 is selected) Yes Yes
STATUS REPLY TIMING ENQ (When STATUS4 is selected) Yes Yes
LEGACY STATUS FOR PORT 9100 DISABLE Yes Yes
IGNORE CR/LF NO Yes Yes
Setting Item Initial Value
Default
(User)
Default
(Shipping)