SATO S84 ex - Sensor Error

9 Appendix
351
S84-ex/S86-ex Operator Manual
9.7.3 Sensor Error
Detection of a sensor error is performed by the gap sensor or the I-mark sensor when the pitch sensor is
enabled, and the detection distance of the sensor error varies depending on the condition such as the
type of sensor.
Detection method for each sensor type
Gap Sensor
When using the Gap sensor:
I-mark Sensor
When using the I-mark sensor:
Distance to detect the sensor error
Detection distance of sensor error is determined by the head density and the vertical print area. In
addition, it varies by the setting of the maximum media length.
1) Detection distance of sensor error by the vertical print area
Head density
Vertical print area after editing
V > 1250 mm 1250 mm ≥ V > 510 mm 510 mm ≥ V
8 dots/mm (203 dpi) 2510 mm 1250 mm 510 mm
12 dots/mm (305 dpi) 1510 mm 1250 mm 510 mm
24 dots/mm (609 dpi) 1250 mm 1250 mm 510 mm
Detection of sensor error
Slice level
Setting value of sensor error detection
distance
Detection of sensor error
Slice level
Setting value of sensor error
detection distance