SATO S84 ex - Test Print Mode

4 Operation and Configuration
190
S84-ex/S86-ex Operator Manual
4.2.17 Test Print Mode
The flowchart shows the sequence of the setting screens for the test print mode. The table describes
each setting screen in detail.
Note
• When EXTERNAL SIGNAL in the ADVANCED MODE menu is set to ENABLE, the product is unable to
perform the test print correctly.
Make sure that the EXTERNAL SIGNAL is set to DISABLE before perform test print.
• When RFID mode is enabled, RFID related information is printed on the second page of the
CONFIGURATION test print.
Test print
When the
above
TEST
PRINT
MODE is
set as
FONT or
MEMORY
Press button
+
Power On
When the above TEST
PRINT MODE is set as
FACTORY or WLAN.
When the above TEST
PRINT MODE is set as
CONFIGURATION,
BARCODE or HEAD CHECK.
or
button
or
button
or button
* Press the , , or button to
select an item or set the value
accordingly. The active arrow icons
are shown on the screen.
* Pressing the button on each
screen will revert to the TEST
PRINT MODE menu.
button
button
WLAN shows only if a
wireless LAN unit is installed.
button
button
button
button
When the above TEST
PRINT MODE is set as
CONFIGURE LIST.
button
;;FP
PP