SATO S84 ex - Loading the Emulation Module

5 Emulation Mode
238
S84-ex/S86-ex Operator Manual
5.1.1 Loading the Emulation Module
In the emulation module loader, user can select to load the standard or emulation module. The valid
downloaded emulation module is listed on the display. A total of four emulation modules can be
downloaded to the memory of product. However, it is subject to the download area availability and other
prevailing condition. The product will not support SBPL command data printing while using the emulation
module.
The flowchart shows the sequence of the setting screens for loading the emulation module. The table
describes each setting screen in detail.
MODULE LOAD
Select the module to be loaded to the product using the / buttons and
then press the ENTER button.
• STD FIRMWARE: Load the standard firmware.
• SZPL (XX.XXX): Load the downloaded SZPL emulation firmware.
• SDPL (XX.XXX): Load the downloaded SDPL emulation firmware.
• SIPL (XX.XXX): Load the downloaded SIPL emulation firmware.
Note
The XX.XXX is the module version information.
Select LOAD
+ button
'(/(7(
'2:1/2$'
02'8/(6(77,1*
/2$'
'(/(7(
02'8/(6(77,1*
(08/$7,21
6,3/;;;;;
02'8/(/2$'
(08/$7,21
6'3/;;;;;
02'8/(/2$'
67'),50:$5(
6=3/;;;;;
02'8/(/2$'
02'8/(6(77,1*
6$9(&203/(7('
5(%227
35,17(512:
button
3 beeps
21/,1(
47<
Product
restart
Emulation icon shows if
emulation module is
loaded.
button