7 Maintenance
293
S84-ex/S86-ex Operator Manual
8 Pull back and arrange the cables from
the top of the print head assembly.
9 Install the print head to the print head
assembly.
Align the print head and press the print head
upward until it is latched.
10
Attach the cover back to the top of the
print head assembly with the
thumbscrew .
CAUTION
When attaching the cover, be careful not to pinch the
wire.
After replacement
• Set the print head selection. (Only for S86-ex series model with the firmware version later than
61.00.00.06.)
In SERVICE MODE, press the ENTER button repeatedly until the HEAD SELECT screen is
shown. Select the options according to the first fourteen to fifteen characters of the print head serial
number and then press the ENTER button.
• Adjust the print darkness.
• Make sure that the print head opens and closes without difficulties.
7.3.2
Replacing the Platen Roller
You can easily remove and replace a damaged or worn platen roller.
1 Make sure that the product is in power off
mode, then disconnect the power cord
from the AC outlet.
2 Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.
To Next Page
Loading...
