SATO S84 ex - Page 151

4 Operation and Configuration
149
S84-ex/S86-ex Operator Manual
HEAD SELECT
Set the type of print head installed in the S86-ex.
Select according to the first fourteen to fifteen characters of the print head
serial number.
The selection varies depending on the print head density.
Note
• Shows only for S86-ex series model with the firmware version later than
61.00.00.06.
• If the installed print head and the selected type do not match, the printing
cannot be done correctly. Be sure to set correctly for correct printing.
S86-ex (203 dpi):
S86-ex (305 dpi):
SAVE USER DEF.
This is a screen for saving service mode and advanced mode settings
performed by the user as default settings.
• YES: Save the product settings.
• NO: Do not save the product settings.
Note
The product can be initialized to this setting at a later time. Refer to
Section 4.2.18 Default Setting Mode.
DEFAULT SETTING COMPLETED
Shows when the product settings have been saved completely.
Note
The setting will be effective after you power on the product again.