SATO S84 ex - Page 152

4 Operation and Configuration
150
S84-ex/S86-ex Operator Manual
Counter Clear
The flowchart shows the sequence of the counter clear function. The table describes each setting screen
in detail.
COUNTER CLEAR
Select one of the followings.
• NONE: Does not clear any counter.
• HEAD: Clear the head counter.
• DISPENSE: Clear the dispense counter.
• BELT (GEAR BOX): Clear the counter of gear box timing belt.
• BELT (RIBBON): Clear the counter of ribbon timing belt.
CONFIRM COUNTER CLEAR HEAD
Select whether to clear the head counter or not.
• YES: Clear the head counter.
• NO: Does not clear the head counter.
%(/75,%%21
%(/7*($5%2;
button
Select COUNTER
CLEAR + button
* Press the or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the button on each screen will revert to the SERVICE
MODE setting screen.
',63(16(
121(
+($'
&2817(5&/($5
&21),50&2817(5
&/($5+($'
<(6
12
&21),50&2817(5
&/($5',63(16(
<(6
12
Select HEAD
+ button
Select YES
+ button
Select NO
+ button
or button
Select DISPENSE
+ button
&21),50&2817(5
&/($5%(/75
<(6
12
&21),50&2817(5
&/($5%(/7*
<(6
12
Select BELT
(GEAR BOX)
+ button
Select BELT
(RIBBON)
+ button
Clear the selected counter and proceed to SERVICE MODE setting screen.
Select YES
+ button
Select YES
+ button
Select YES
+ button
%(/75,%%21
%(/7*($5%2;
',63(16(
121(
+($'
&2817(5&/($5
&21),50&2817(5
&/($5+($'
<(6
12