SATO S84 ex - Print Problem

2 Installing the Product
33
S84-ex/S86-ex Operator Manual
3 Connect the applicator cable from the EXT connector of the product to the applicator.
Use a cable that is compatible with the standard of the interface board as stated in Section 9.12
Interface Specifications. Check the orientation of the connector before you make the connection.
CAUTION
Do not connect or disconnect the interface cables (or use a switch box) with power supplied to either the
product or computer. This action may cause damage to the interface circuitry in the product or computer. The
warranty does not cover such damages.
2.4.3 Interface Settings
You can set the various interface settings of the product through the interface mode menu. For details,
refer to Section 4.2.10 Interface Mode.
In interface mode, you need to configure both the data port and sub port. An overview of each port is
shown below.
Data port
When the interface is set to the data port, it can receive various SBPL commands and receive print data
from the host computer.
Data port selection: USB, LAN, RS-232C, IEEE1284, Bluetooth, WLAN (Wireless LAN)
The optional Bluetooth and optional wireless LAN are available if you have installed them.
* You cannot select the interface that has already been set for the SUB PORT.
Sub port
This port is for monitoring the status of the product.
Sub port selection: NONE, USB, LAN, RS-232C, IEEE1284, Bluetooth, WLAN (Wireless LAN)
The optional Bluetooth and optional wireless LAN are available if you have installed them.
* You cannot select the interface that has already been set for the DATA PORT.
Note
The main port and sub port cannot simultaneously use the same interface.
Sub port
- Product status
Data port
- SBPL command (Print data)
- Product status