SATO S84 ex - More about the Media Stop Position

6 Adjusting the Product
264
S84-ex/S86-ex Operator Manual
Adjust the stop position using the following procedure:
1 Make sure that the product is in online mode or offline mode.
2 Press the and buttons for one second
to enter the adjustment mode.
PITCH POSITION shows on the screen.
3 Press the ENTER button to go to the
next adjustment screen.
OFFSET POSITION shows on the screen.
4 Change the setting value. Press the /
buttons to set the desired value.
Set the offset value with ‘+’ to move the stop
position opposite the feed direction, and value
with ‘-’ to move the stop position in the feed
direction.
The setting value is adjustable by 0.25 mm (0.01”)
regardless of the print resolution.
The setting range is from -3.75 mm (-0.15”) to
+3.75 mm (+0.15”).
5 Press the ENTER button to save the
setting and proceed to the next
adjustment screen.
6.1.4 More about the Media Stop Position
Stop position of the label in dispenser
mode.
The regular position is to let the label stay about 1
mm (0.04") on the liner.
Stop
position
Feed direction