SATO S84 ex - Replacing the Fan Filter

7 Maintenance
298
S84-ex/S86-ex Operator Manual
8 Insert the gear end of the new media
feed roller  fully into the center frame
of the product.
9 Place the bearing  back to the chassis
and the shaft of the media feed roller.
10 Rotate the bearing clamp  onto the
bearing  and attach it with the screw
.
7.3.5 Replacing the Fan Filter
The fan filter prevents atmospheric debris from being drawn into the product.
1 Peel off the old fan filter  from the rear
of the product.
2 Clean the product to remove any
adhesive residue on the surface.
Note
You can purchase a cleaning kit from a SATO reseller
or technical service center.
3 Remove the backing paper from the new
fan filter  and paste the fan filter 
over the fan exhaust holes.
7
5
4
6
1