SATO S84 ex - Adjusting the Media Stop Position

6 Adjusting the Product
263
S84-ex/S86-ex Operator Manual
3 Change the setting value. Press the
/ buttons to set the desired value.
Set the offset value with ‘+’ to move the print
position opposite the feed direction, and value
with ‘-’ to move the print position in the feed
direction.
The setting value is adjustable by 0.25 mm (0.01”)
regardless of the print resolution.
The setting range is from -3.75 mm (-0.15”) to
+3.75 mm (+0.15”).
4 Press the ENTER button to save the
setting and go to the next adjustment
screen.
6.1.3 Adjusting the Media Stop Position
The stop position for options (such as Dispenser) is adjustable within the range of +3.75 mm to -3.75 mm
(+0.15” to -0.15”) in the adjustment mode described above.
Note
The above dispensing position for printing indicates the label stop position when the media sensor is set to
Gap sensor.
Adjustment Location Adjustment Range
Adjustment Mode: Offset Position +3.75 mm to -3.75 mm
(+0.15” to -0.15”)
-3.75 mm (-0.15”) ~ +3.75 mm (+0.15”)
Media feed direction
Print position
(Print head)
Adjustment for
“+” value
No
adjustment
Adjustment for
“-” value
Dispensing
position