SATO S84 ex - Page 360

9 Appendix
358
S84-ex/S86-ex Operator Manual
When a gap exists in the back of the label
The figure and table below show the distance (A) from the end of printing to the next print start position
with backfeed for printing. It also shows the consumption of the ribbon (B) when the ribbon saver is
operating.
Condition
(1) Print operation Backfeed
(2) Setting Dispense distance 14 mm (0.55”)
PITCH and OFFSET of OFFSET VOLUME should be set to 0.00,
PITCH OFFSET should be set to 0.
(3) Print position Vertical print position is V001.
The ribbon consumption might be different from the value in the above table depending on the ribbon
condition.
(unit: mm)
Print speed
(inches/sec)
Distance (A)
Ribbon
consumption (B)
2 4.0 2.5
3 4.0 2.5
4 4.0 2.5
5 4.0 2.5
6 4.0 2.5
7 4.0 2.5
8 4.0 2.5
9 4.0 3.0
10 4.0 3.0
11 4.0 3.5
12 6.0 3.5
13 8.0 5.5
14 9.0 7.5
15 11.0 9.0
16 13.0 11.0
<Label> <Ribbon>
Media feed direction
Print data
(A)
Print data
Print data
(B)
Print data