SATO S84 ex - Page 359

9 Appendix
357
S84-ex/S86-ex Operator Manual
When a gap exists in the print data
The figure and table below show the minimum distance (A) required from the end of printing to the next
print start position. It also shows the consumption of the ribbon (B) when the ribbon saver is operating.
The ribbon consumption might be different from the value in the above table depending on the ribbon
condition.
(unit: mm)
Print speed
(inches/sec)
Distance (A)
Ribbon
consumption (B)
2 11.0 9.5
3 12.0 10.0
4 13.0 10.5
5 14.0 11.0
6 16.0 12.0
7 16.0 13.5
8 18.0 15.0
9 19.0 15.0
10 21.0 15.5
11 22.0 16.0
12 24.0 17.5
13 26.0 19.0
14 27.0 20.0
15 29.0 22.0
16 31.0 26.0
<Label> <Ribbon>
Media feed direction
Print data 1
(A)
Print data 2
Print data 1
(B)
Print data 2