SATO S84 ex - Page 172

4 Operation and Configuration
170
S84-ex/S86-ex Operator Manual
LABEL SIZE ADJ HEIGHT
Specify the height of the label for rotation.
The setting range varies depending on the following models:
Note
Shows only if ROTATE LABEL is set to 90, 180 or 270.
IGNORE A1
Select whether or not to ignore the <A1> command.
<A1> command is to set the media size.
Refer to the Programming Reference for details on the command.
• YES: Ignore the <A1> command.
• NO: Proceed with the <A1> command.
Note
Shows only if ROTATE LABEL is set to 90, 180 or 270.
PAPER END
Select the type of sensor used for detecting paper end.
• I-MARK: Use I-mark sensor to detect paper end.
• GAP: Use Gap sensor to detect paper end.
Model Name Setting Range
(dot)
Default Value (dot)
S84-ex (203 dpi) 00000-20000 20000
S84-ex (305 dpi) 00000-18000 18000
S84-ex (609 dpi) 00000-09600 09600
S86-ex (203 dpi) 00000-09992 09992
S86-ex (305 dpi) 00000-14988 14988
,0$5.
*$3
3$3(5(1'