SATO S84 ex - Page 134

4 Operation and Configuration
132
S84-ex/S86-ex Operator Manual
Function Settings
The flowchart shows the sequence of the setting screens for the function settings. The table describes
each setting screen in detail.
02'(
button
button
button
Select SETTING
+ button
Shows only if EXTERNAL REPRINT is set to ENABLE,
REPRINT W/FEED is set to YES, FUNCTION KEY is set to
REPRINT, or CONTINUOUS PRINT is set to ENABLE.
button
button
button
button
button
button
button
button
button
button
button
button
* Press the , , or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the button on each screen will revert to the SERVICE
MODE setting screen.
35(1'7<3(
1250$/
027,21
button
Shows only if you have installed the optional RFID kit and
enabled the RFID mode.
)25:$5'%$&.)(('
'()$8/7 PP
',67$1&(
'$7$5($'<
'$7$35(6(17
3515($'<7<3(
button
button
Shows only if EXT 9PIN SELECT is set to MODE3.
Proceed to .
S-A