SATO S84 ex - KB Download Mode

Before You Start
12
S84-ex/S86-ex Operator Manual
Precautions for Installation and Handling
Product operations can be affected by the product’s environment.
Refer to the following instructions regarding how to install and handle the product.
Select a Safe Location
Power Supply
Printing
The print result varies depending on the usage environment (temperature and humidity), the supply condition
(the combination of media and ribbon), and the product settings (the print speed, the print darkness, etc.).
Please sufficiently test the product in your usage environment, and use it with the optimal combination.
If anything is unclear, or if you have any questions, contact your SATO reseller or technical support center.
Place the product on a surface that is flat and
level.
If the surface is not flat and level, this may cause bad
print quality. This may also cause a malfunction and
decrease the life span of the product.
Do not place the product on a location that
produces vibration.
Subjecting the product to severe vibration or shock
may cause a failure or damage to the product,
leading to a product malfunction.
Keep the product out of high temperature and
humidity.
Avoid locations subject to extreme or fast changes in
temperature or humidity.
Do not install the product in a location exposed to
water or oil.
Water or oil entering inside the product may cause a
fire, electric shock or malfunction.
Avoid dust.
Dust build up may cause lowered print quality, faults,
or malfunctions.
Keep out of direct sunlight.
The product has a built-in optical sensor. Exposure
to direct sunlight may cause incorrect detection by
the sensor so the product does not operate normally.
Therefore, close the cover when using the product.
Do not use in hazardous locations.
Do not use in a potentially explosive environment or
atmosphere. Doing so could cause a fire or
explosion.
The product requires an AC power supply.
Be sure to connect the product to an AC power
supply.
Connect the power cord to a grounded AC outlet.
Make sure that the product is connected to a
grounded AC outlet.
Supply a stable source of electricity to the
product.
When using the product, do not share its AC outlet
with other electrical devices. This could cause power
fluctuations and performance issues with your
product.