SATO S84 ex - Page 257

5 Emulation Mode
255
S84-ex/S86-ex Operator Manual
FORMAT ATTRIBUTE
Set the format attribute.
The options are as follows:
• XOR
• TRANSPARENT
• OPAQUE
• INVERSE
Note
Shows only if FORMAT ATTRIBUTE PRIORITY is set to LCD.
PAUSE MODE PRIORITY
Set the priority of the pause mode.
Two options can be selected as follows:
• COMMAND: The setting is according to SDPL command.
• LCD: The setting is according to PAUSE MODE screen.
PAUSE MODE
Enable or disable the pause mode.
• ENABLE: Enable the pause mode. The product enters offline mode
after every print job if priority setting is set to LCD. It has the same
effect as <STX>J.
• DISABLE: Disable the pause mode.
Note
Shows only if PAUSE MODE PRIORITY is set to LCD.
1-BYTE CODEPAGE PRIORITY
Set the priority of the 1-byte codepage.
Two options can be selected as follows:
• COMMAND: The setting is according to SDPL command.
• LCD: The setting is according to 1-BYTE CODEPAGE screen.
&200$1'
35,25,7<
3$86(02'(
/&'
&200$1'
35,25,7<
%<7(&2'(3$*(
/&'