SATO S84 ex - Page 308

8 Troubleshooting
306
S84-ex/S86-ex Operator Manual
40
Cover open error
Flashes red.
Three short beeps.
To clear the error:
Close the cover.
The cover is opened. Close the cover.
The sensor for sensing
the open/close status of
the cover is defective.
Contact your SATO
reseller or technical
support center to replace
the sensor.
41
Saver error
Lights red.
One long beep.
To clear the error:
Power off the
product.
The print head cannot
stop at the specified
position.
Adjust the saver head
position.
Contact your SATO
reseller or technical
support center to replace
the saver sensor, replace
the saver motor and
motor driver PCB, or
replace the saver cam.
42
Sensor cover open
error
Flashes red.
Three short beeps.
To clear the error:
Close the sensor
cover.
The sensor cover is
unlocked.
Lock the sensor cover.
The sensor for sensing
the open/close status of
the sensor cover is
defective.
Contact your SATO
reseller or technical
support center to replace
the sensor.
Error
No. Message LED/Buzzer Cause Countermeasure
40
40
41
41
42
42