SATO S84 ex - Page 351

9 Appendix
349
S84-ex/S86-ex Operator Manual
Paper End Detection in Print Motion
Operation varies by the number of remaining print steps when the paper end occurs during print
operation.
The following illustrations show I-mark is used as paper end sensor.
[When the print content falls within the area from the print head position to 15 mm (0.6”) less than
the I-mark sensor.]
• After completing the print of media (1), paper end error will occur.
• After releasing the error, media (1) will not be printed again.
Media feed direction
Print head
I-mark sensor
15 mm
(0.6”)
(1) (2)
Media feed direction
Print head
I-mark sensor
15 mm
(0.6”)
(1) (2)
When the print
content falls
within this area