9 Appendix
383
S84-ex/S86-ex Operator Manual
Note
• When using the READY/BUSY control, make sure that the product is in power on mode before you send the
data from the host.
• With communication protocols such as XON/XOFF, STATUS3, STATUS4 or STATUS5, a receive buffer full
error will occur when the received data is more than the receive buffer size (2.95 MB). Send data that is less
than 2.95 MB while monitoring the status of the product.
• A parity error will be detected if this error occurs after the reception of ESC+A.
Cable Specifications
Cable Connector DB-9 Male or equivalent
Cable Length 5 m (16.4 feet) or less
To Next Page
Loading...
