SATO S84 ex - Page 389

9 Appendix
387
S84-ex/S86-ex Operator Manual
Connector Pin Specifications
Pin No.
I/O Description
(25 pins) (14 pins)
1 14 - Frame Ground
2 - - Vcc +5 V (Maximum current 600 mA)
600 mA in total for Pin No. 2 and 12.
3 - Output Print Start Position Signal (HOME POS.)
When backfeed motion is set to CONTROLED, outputs a low signal
when backfeed is done.
4 4 Output Machine Error:
Outputs a low signal when an error such as cover open error, head
open error or communication error, etc. is detected.
5 6 Output Print End Signal (PREND):
Outputs a low signal when the media print is completed.
69Output
Online*
3
:
Outputs a low signal when the product is in offline mode.
7-
Input*
2
Label Near End:
Product received a label near end signal when a low signal is
detected.
87
Input*
2
Reprint Signal (PRIN2):
Prints the previously printed content again when a low signal is
detected.
9-
Input*
2
Backfeed Order (DISPENSE IN)
When backfeed motion is set to CONTROLED, perform a backfeed
when a low signal is detected.
10 -
Input*
2
Reserve
11 - - OUT_COM: Ground of peripherals
12 13 - Vcc +5 V (Maximum current 600 mA)
600 mA in total for Pin No. 2 and 12.
13 12 - VCC +24 V (Maximum current 2 A)
14 2 - GND: Reference Signal Ground
15 2 - OUT_COM: Ground of peripherals
16 3 Output Ribbon End:
Outputs a low signal when the ribbon end is detected.
17 1 Output Paper End:
Outputs a low signal when the paper end is detected.
18 10 Output Ribbon Near End:
Outputs a high signal when the ribbon near end is detected.
19 - Output Reserve
20 5
Input*
2
Print Start Signal (PRIN):
Prints one media when a low signal is detected.