SATO S84 ex - Page 72

4 Operation and Configuration
70
S84-ex/S86-ex Operator Manual
SELECT FILE
Select the file name of the print data using the / buttons and then
press the ENTER button.
The “XXXXXX” in the screen shows the file name of the print data.
Only existing file names in the selected interface are shown.
When sequential data are included in the file, the product goes to the SET
START NUMBER screen.
When sequential data are not included in the file, the product goes to the
OUTPUT LABEL screen.
SET VARIABLE DATA
This is the edit screen of the variable data included in the read data.
Move the cursor using the
/ buttons, change the value using the
/ buttons and then press the ENTER button.
In the screen, the currently selected file is shown in the first line, the
variable data name in the second line, and the variable data for editing in
the third line.
The variable data name, character type allowed and the maximum length
are specified via commands.
The maximum number of characters is 16.
Note
Shows only if there is variable data.
SET START NUMBER
This is the edit screen of the sequential data included in the read data.
Move the cursor using the
/ buttons, change the value using the
/ buttons and then press the ENTER button.
The “X/X” in the screen shows the currently edited sequential data number
and total sequential data number.
DIGIT is the digit number of the selected cursor.
The screen may be decimal or hexadecimal according to the read data.
The maximum number of DIGIT is 99.
Note
Shows only if there is sequential data.
;;;;;;
)LHOG
