4 Operation and Configuration
97
S84-ex/S86-ex Operator Manual
USB Setting
PROTOCOL
Set the communication protocol.
• STATUS4: When selected, the product will proceed to the IGNORE
CR/LF screen.
• STATUS5: When selected, the product will proceed to the ITEM NO.
CHECK screen.
ITEM NO. CHECK
Set the item number check function.
• ENABLE: Enable the item number check function.
• DISABLE: Disable the item number check function.
Note
Shows only if PROTOCOL is set to STATUS5.
Shows only if
STATUS5 is selected.
* Press the , , or button to
select an item or set the value
accordingly. The active arrow icons
are shown on the screen.
* Pressing the button on each
screen will revert to the INTERFACE
MODE menu.
button
button
button
button
button
button
I-A
Proceed to .
I-F
To Next Page
Loading...
