EasyManua.ls Logo

Schaerer Coffee Art TouchIT - Common settings; Milk mix settings

Schaerer Coffee Art TouchIT
154 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.schaerer.com Configuration
PASCA_TOUCHIT_EN
V02 | 07.2013
56
Milk mix settings
7) Dispensing mode (steam) Selection options for steam:
The "Portion control" selection causes a
single portion of steam to be dispensed for a
particular time period.
Pressing "Start" causes steam to be dispen-
sed and "Stop" causes it to stop.
Pressing and holding causes steam to be
dispensed until the field is released again.
Dosed
Start/stop pro-
duct
Press/hold pro-
duct
"Steam" is selected in the
"1 Product type" parame-
ter.
The standard setting is
"Start/stop".
To set the steam quantity,
see the "902 Dosing time"
parameter.
12) Outlet change-over Change over the beverage outlet to the
"Swan neck outlet".
Switch on the "Outlet change-over" pa-
rameter.
The field lights up green.
The beverage outlet is switched over
to the outlet with a "swan neck".
On/off The standard setting is
"OFF".
This parameter only ap-
pears for the "mug" bever-
age setting.
The "19 Outlet change-
over" system parameter
must be switched on.
13) Pump pressure Builds additional pressure with the water
pump:
Switch on the "Pump pressure" parame-
ter.
The field lights up green.
The water flows with additional pump
pressure.
On/off The standard setting is
"OFF".
When the parameter is
switched off, the water
pressure is supplied by the
water mains only.
This parameter only ap-
pears for the "mug" bever-
age setting.
Parameters: Common Settings
Display text Description Setting range Notes
Parameters: Milk mix settings
Display text Description Setting range Notes
601) Select milk Selection menu for the desired milk source
for the previously selected beverage.
In the selection menu, select the desired
milk source for the beverage.
The beverage is prepared using the
selected milk source.
Milk left
Milk right
Blended milk
"Twin Milk" must be
selected in the "07 Fresh
milk" system parameter.
602) Milk balance Milk mixing ratio when equipped with "Twin
Milk"
Set the mixing ratio using the grey field.
The beverage is prepared using milk
from both milk sources in the set milk
mixing ratio.
Left milk sour-
ce: 1-99%
Right milk sour-
ce: 1-99%
The mixing ratio setting for
the two milk sources requi-
res the "Twin Milk" milk sy-
stem, and "Blended milk"
must be set in the "601
Select milk" parameter.

Table of Contents

Related product manuals