PASCA_TOUCHIT_EN
V02 | 07.2013
69
www.schaerer.comConfiguration
External alarm display
15) Fill milk hose Sets the filling time of the milk hose.
Fills the milk hose with fresh milk after rin-
sing.
Advantages:
This removes residual water from the milk
hose. The milk dosing remains constant.
0.0-19.9 sec The standard setting is
0min.
Milk is not filled if set to "0".
"Milk pump", "Center milk"
or "Twin Milk" must be
selected in the selection
list of the "7 Fresh milk sy-
stem" system parameter.
Setting with "CS" milk system 1 sec
Setting with "UC" milk system Depends on the
distance bet-
ween the coo-
ling unit and the
machine.
Parameters: Date / Time / Alarm
Display text Description Setting range Notes
Parameters: Alarm output
Display text Description Setting range Notes
Fig. Connection "J4-8" of the external
alarm display
The alarms are signalled using an external
customer-specific alarm system.
This alarm system can signal visually with a
lamp or acoustically with a horn.
If a parameter is switched on in the "Alarm
output" menu, alarms are transmitted to the
connected display device via terminal "J4-8".
The "Alarm output" function makes it possib-
le for users to detect alarms from a distance
when the machine is used in "Self" mode.
- The alarm output is found
at connection J8, pins 7 &
8, see Fig. "External alarm
display".
If an alarm output is active,
30 V CC are applied at ter-
minal J4-8.
A cable 069715 is needed
to connect the output to an
external 24 V CC Potter &
Brumfield relay (063770).
The "19 Outlet change-
over" system parameter
must be deactivated.
To Next Page
Loading...
