Schaerer Coffee Art TouchIT - Date; Time; Alarm

www.schaerer.com Configuration
PASCA_TOUCHIT_EN
V02 | 07.2013
68
10) Service request after months Specifies the interval in months until a ser-
vice request appears.
► Enter the number of months.
Message:
When the set interval is reached, a message
appears on the display.
This message can only be cleared using the
SERVICE card.
See "Info" - "Counters and statistics"- "Ser-
vice counters".
Pre-warning message:
When the remaining time has dropped below
30 days, a daily message appears at 1:00
p.m. as a pre-warning.
Confirm the message with [OK].
► Reset the counter during the initial instal-
lation using the "1 Last service" parame-
ter.
See "Info" - "Counters and statistics"- "Ser-
vice counters".
0-24 months The standard setting "0" is
without a message.
11) Hot rinsing milk Sets the hot rinsing interval in minutes.
With "Milk Smart":
Rinses the milk outlet and steam nozzle
using water from the coffee boiler. In bet-
ween there is a restrictor of 0.6 mm.
With "milk pump":
Rinses the milk outlet and milk pump using
water from the hot water boiler. In between
there is a restrictor of 0.6 mm.
0-180 min The standard setting is
90 min.
Rinsing does not occur if
set to "0".
A fresh milk system must
be selected in the system
parameter.
12) Repeat milk rinse Sets the repetition interval for hot rinsing in
minutes.
Repeats hot rinsing at the set interval until a
milk product is dispensed.
This is recommended for 24 h operation and
if few milk beverages are dispensed.
For the rinsing procedure, see the "9 Hot
rinsing milk" parameter.
0-180 min The standard setting is
90 min.
Repeated rinsing does not
occur if set to "0".
A fresh milk system must
be selected in the system
parameter.
Note the setting in the "11
Hot rinsing milk" parame-
ter.
13) Hot rinsing brewer Sets the hot rinsing interval in minutes.
Hot rinsing takes place after a coffee bever-
age is output following the time interval set
here.
When a coffee beverage is output, the coun-
ter is reset to "0".
0-90 min The standard setting is
0min.
Hot rinsing does not occur
if set to "0".
After rinsing, the brewing
cylinder and sieve are wet.
As a result, there is a risk
that a water flow error
could occur while the next
product is being dispen-
sed.
14) Parameter is deactivated No function - -
Parameters: Date / Time / Alarm
Display text Description Setting range Notes