51
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
4. The receiver reboots, and new setting takes effect after the reboot.
5.3.3.2 Setting up P2P Operating Channel (AGO Mode Only)
When AGO is enabled, users are allowed to define an operating channel for communication
between the wireless display receiver and the source device.
This feature is available in AGO mode only.
To set up the receiver’s operating channel, follow this procedure:
1. Go to the Features tab page by clicking the Features tab.
2. Go to the P2P Wireless Setting section, and select a desired channel from the P2P
Operating Channel drop-down box.
Channels from 1 to 13 belong to the 2.4 GHz band; and channels from 36 to 165 belong to
the 5 GHz band. By default, channel 165 is used.
Availability of channels depends on the sales region (country code).
You should select a channel based on your network environment. Generally, cleaner
channels (where less devices work) will provide better performance. You can use Wi-Fi
Analyzer to help you identify a clean channel.
Note: ScreenBeam receivers do not support Dynamic Frequency Selection (DFS) channels,
50 through 144, because it's prohibited in a direct Wi-Fi usage model. You should
disconnect your source device from the DFS-capable router (AP) or connect to a non-DFS
To Next Page
Loading...
