ScreenBeam 960 - Setting up the Receiver’s IP Address

79
5.3.7.2 Setting up the Receiver’s IP Address
To set up the receiver’s IP address, follow this procedure:
1. Go to the Remote Management tab page by clicking the Remote Management tab.
2. Go to the TCP/IP Setting section, and set the IP Assignment to Auto or Static.
 Auto: The receiver will be assigned an IP address by the DHCP server.
 Static: Users are allowed to define the IP address, subnet mask, and default gateway
for the receiver. If Static is selected, it is required to define a DNS server as well.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.