72
5.3.6 Local Management Settings
This section introduces local management related settings, such as local management
interface access, local management communication port, network information display,
receiver’s SSID.
5.3.6.1 Setting up Local Management Interface Access
The receiver’s Local Management Interface (LMI) is used to manage the receiver locally.
To set up the receiver’s LMI access, follow this procedure:
1. Go to the Local Management tab page by clicking the Local Management tab.
2. Go to the Local Management Access section, and select an option from the Local
Management Interface Access box. There are three options available: Auto, Enable,
and Disable.
Auto: The accessibility to the receiver’s LMI depends on the availability of the
CMS connection. When the receiver is connected to CMS, access to the receiver’s
LMI is disabled automatically, and the receiver’s SSID is not displayed in NGO
mode; otherwise, access is enabled.
Enable: Access to the receiver’s LMI is enabled no matter the receiver is
connected to CMS or not.
Disable: Access to the receiver’s LMI is not allowed, and the receiver’s SSID is not
displayed in NGO mode.
To Next Page
Loading...
