86
Do not make any change to the extracted files.
3. Make sure the "Wireless Display Ready To connect" screen appears on your TV.
Note: You must disconnect your device (laptop, ultrabook, smartphone or tablet) from
the receiver before upgrading your receiver.
4. Ensure that the Firmware Upgrade via USB Autorun feature is set to Enable on LMI >
Firmware Upgrade.
5. Plug the USB flash drive into the USB port on the receiver.
6. The receiver starts to update its firmware automatically. Firmware upgrade status
messages appear on your TV.
Warning! Do not power off the receiver or remove the USB flash drive while the
upgrade is in progress. Otherwise, firmware upgrade fails.
7. The receiver reboots after firmware update completes.
8. You may now remove the USB flash drive when you see the "Wireless Display Ready
to connect" screen again.
To Next Page
Loading...
