93
I'm seeing choppiness and brief pauses while watching local video on my Miracast™
device.
Wireless interference may cause the video playback to be choppy. If this occurs, try the
following:
•
Make sure you are in the same room as the Receiver is.
•
Set the media player to use the H/W decoder, if available.
•
Reboot the Miracast™ device and Receiver and connect again.
•
Avoid moving the Miracast™ device around too much.
•
Change the wireless channel on your wireless router/access point, or on your receiver.
My Windows 8.1 displays to the TV but the four edges are cut off (overscan).
This is expected with some system's supported display resolution. You can adjust Windows
screen resolution settings to fit the PC's screen on your TV display.
I encounter connection failure with ScreenBeam 960 and my device can’t connect to it
any more.
Reboot the ScreenBeam 960 and try connection again. Or, reboot your device
(laptop/Ultrabook/tablet/smartphone) and try connection again.
Reboot both the ScreenBeam 960 and your device and try connection again.
If you are using a Windows 8.1 operating system, go to Change PC settings > PC and
Devices > Devices > Projectors, remove the profile of the ScreenBeam 960 from your
device (PC/laptop/Ultrabook), and try connection again.
If you are using a Windows 10 operating system, go to Settings > Devices >
Connected Devices > Projectors, remove the profile of the ScreenBeam 960 from
your device (PC/laptop/Ultrabook), and try connection again.
I can’t connect to the Receiver with ScreenBeam Configuration Utility on my device.
The Utility can’t find the Receiver.
ScreenBeam 960 is not compatible with ScreenBeam Configuration Utility. To configure or
upgrade the receiver, you should use the receiver’s Local Management Interface or
ScreenBeam Central Management System.
When I connect the source device to a wireless network (router/AP), why
ScreenBeam 960 disconnects automatically?
The source device’s communication channel has changed when you connect your device to
a wireless network (router/AP) in the situation that the source device is connected to
ScreenBeam 960. As a result, ScreenBeam 960 disconnects from the source device.
The solution is that you should connect your device to the wireless network before
connecting it to ScreenBeam 960. In this way, ScreenBeam 960 works on the same channel
with the source device and the wireless network, and no connection interruption will occur.
To Next Page
Loading...
