Mobile DaRt Operation Manual
10
NOTE
Use the following cassettes for the bucky device.Other cassettes should not
be used.
CM or INCH size cassettes based on IEC standard 60406.
Attenuation equivalent not greater than 1.6mm Al.
Less than 15mm thickness.
All parts of the cassette such as hinges, locks and marking device shall be
within the minimum radii for carners and edges.
Flatness shall be less than 1mm warp.
Language of Approved Version
NOTE
Original version of this manual is approved in English.
Software Revision
This manual applies to the software revision 1.0
Disposal of the Products and Parts
This system contains materials that can contaminate the environment not displosed
of properly. For the disposal of this product or any of its attachments, contact your
nearest authorized Shimadzu service center.
To Next Page
Loading...
Need help?
General
