4.3 Moving the System
Mobile DaRt Operation Manual
4-13
4.3.5 Bumper Switch
The bumper switch is located at the lower front part of the system. If the bumper
switch hits an obstacle, the system will stop. In this case, the system can only
be moved backwards.
Fig. 4-6 Bumper switch
WARNING
With the “Bumper switch canceling function” enabled, move the system
with care, paying special attention to the surroundings. If the system
hits any equipment or person, it may damage the equipment or injure
the person.
Bumper switch canceling function
If a bumper switch fault occurs, the bumper switch can be temporarily
disabled.
To enable this function:
1. Turn the key switch to “OFF” position .
2. Turn the key switch “ON” while pressing the “Collimator lamp”
switch .
At this time the “Battery charge indicator lamp” blinks, indicating the
bumper switch is disabled.
Bum
er switch
To Next Page
Loading...
Need help?
General
