Chapter 4 How to Operate
Mobile DaRt Operation Manual
4-22
Setting of the radiographic X-ray tube voltage (kV)
The setting value is shown on the radiographic X-ray tube voltage
display.
Pressing the switch [＋]
to increase the X-ray tube voltage in 1-kV
increments.
Pressing the switch [−] to decrease the X-ray tube voltage in 1-kV
decrements.
Keep [＋] or [−] switch pressed to accelerate the change of the setting
value.
Setting of the radiographic current time product (mAs)
The set value is shown on the display for the current time product
Pressing the switch [ ＋ ]
increases the product in 1-step
increments.
Pressing the switch [ − ]
decreases the product in 1-step
decrements.
Keep [＋] or [−] switch pressed to accelerate the change of the setting
value.
4.6.3 Setting Method with Anatomical Programs
How to select an anatomical program
One of the registered exposure conditions can be selected by
operating the switch on the X-ray control panel.
1. Filming regions
“Head” , “Chest” , “Abdomen” , “Waist” ,
“Leg” , “Foot” , “Arm” and “Hand”
2. Filming orientations
“Front” (AP) , “Side” (Lateral) and “Oblique”
3. Body thickness correction
Select one from:
“Thin” , “Normal” and “Obese”
The LED of the selected switch illuminates.
To Next Page
Loading...
Need help?
General
