SICK Flexi Classic - STEP 4 - Assign the device name

Operating Instructions Chapter 10
Flexi Classic Gateways
8011834/YT28/2016-03-15 © SICK AG • Industrial Safety Systems • Germany • All rights reserved
127
Subject to change without notice
PROFINET IO Gateway
10.3.4 STEP 4 — Assign the device name
In order for the PLC to communicate with the UE410F EN4, the PLC software and the
gateway must agree on the name of the gateway.
Specify the gateway’s PROFINET IO device name
 Double click on the gateway hardware symbol.
 Select the General tab.
 Enter the desired device name in the dialog as shown below:
The device name format shall apply to the PROFINET standard specification.
Note