Chapter 7 Operating Instructions
Flexi Classic Gateways
64 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8011834/YT28/2016-03-15
Subject to change without notice
Modbus/TCP Ethernet Gateway
7.6 Resetting to factory settings
T
he UE410-EN can be reset to the factory settings as follows:
Open a web browser on a PC in the same network and go to the address of the
UE410FEN. The following web page is displayed:
Click the reboot button. The following web page is displayed:
Activate Set configuration for PLC Interface and Data Sets to factory default settings.
Click the button Yes: Reboot. The following web page is displayed:
The UE410-EN is reset to the factory settings. The web server of the UE410-EN is called up
again automatically.
To Next Page
Loading...
Need help?
General
