14
8024638/AE00/V1-0/2019-09| SICKSERVICE MANUAL | MCS200HW
Subject to change without notice
3 MAINTENANCE
3.4 Working on the cell
Fig. 4: MCS200
1 Disconnect the MCS200HW power supply.
2 Let the MCS200HW cool down.
3 Loosen the fastening screws of the cell cover on the right and left with a Phillips screw-
driver (4 pieces).
DANGER: Risk of burns due to hot surface.
Allow the MCS200HW to cool down before carrying out any work.
NOTE: Do not switch off the instrument air supply.
Tools required
Phillips screwdriver
1Cell
2 Sender/receiver unit with electronics unit
Do not remove the screws, only loosen them.
To Next Page
Loading...
