139
8024638/AE00/V1-0/2019-09| SICK S E R V I C E M A N U A L | MCS200HW
Subject to change without notice
REPAIRS 5
5.4.4 Replacing the LPMS02 circuit board
Fig. 225: LPMS02
1 Remove the electronics unit (see Chapter “Removing and fitting the electronics unit”,
page 129).
2 Loosen the fastening screws of the upper electronics unit with a Phillips screwdriver.
▸ Top fastening screws (2 pieces).
▸ Rear fastening screws (2 pieces).
Fig. 226: Upper electronics unit, fastening screws, top
Fig. 227: Upper electronics unit, fastening screws, rear
3 Disconnect the ribbon cable and white connection cable at both ends.
▸ To do this, slightly lift the upper drawer and shift it backwards.
Tools required
Phillips screwdriver
7 mm socket wrench
Spare parts set No. Contents
2099752 LPMS02
1Fastening screw
1Fastening screw
To Next Page
Loading...
