Siemens HiPath 1130 - Dids for Entrance Telephones

Step by Step
Entrance Telephone
100
or
Press this key.
Initial state for Programming Mode.
DIDs for Entrance Telephones
You can specify which telephones are to answer the
Entrance Telephone calls (up to 10 extensions).
The default setting is extension 11/101.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot for the extension configured as the Door
Opener (1 to 4).
Enter the extension number (e.g., 12/102) to answer
calls from the Entrance Telephone.
Confirm the extension assigned to the Entrance
Telephone slot.
Enter the next extension number
or
Press this key.
Initial state for Programming Mode.
Deleting DID Extensions
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot for the extension configured as the Door
Opener (1 to 4).
Delete DID extensions.
Press this key.
Initial state for Programming Mode.
#
5 9
1 4
*
#
5 9
1 4
*
#