Siemens HiPath 1130 - Operation as a Satellite PABX; External Line Connection; Second Code for External Access

Programming an External Line
39
Step by Step
Operation as a Satellite PABX
External Line Connection
This feature determines if an external analog line
connected to one of the HiPath 1100 systems is also
connected to a local carrier or another PABX.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the number for the group of external lines (e.g., 0,
890).
or Enter the code for the type of connection:
= Connection to a local carrier (default)
= Connection to another PABX system
Press this key.
Initial state for Programming Mode.
Second Code for External Access
This setting specifies the code used by the main PABX
for accessing external lines. This code is used to check
if there is a dial tone at an external line and to generate
a pause while dialing, redialing or using the speed
dialing feature.
The default setting for the second code is "0."
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... or
...
Enter the external access code for the main PABX (one
or two digits) and wait for a confirmation tone:
... = Second external access code, one dig-
it
... = Second external access code, two
digits
When a group of external lines is programmed as
a Satellite PABX, a false dial tone is not generat-
ed.
3 3
1 2
1
2
#
3 4
0 9 0 0 9 9
0 9
0 0 9 9