Siemens HiPath 1130 - External Line Prefix; External Number Registration

Step by Step
Programming a Digital Trunk
122
External Line Prefix
This setting specifies the prefix for the PABX external
lines, for domestic and international calls. By default,
the type of a programmed called is not specified.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Select the type of call:
= National
= International
Enter the line prefix (up to 5).
Press this key.
Initial state for Programming Mode.
External Number Registration
To use the Attendant feature each external number
must be registered to a specific slot.
If the prefix (Code 089) for these numbers has already
been configured, only the final digits need to be regis-
tered.
By default, no digits are specified.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot (001... 140).
Enter the DID number (up to 20 digits).
Press this key to confirm the entry.
(After entering 20 digits, the entry mode exits automat-
ically.)
... Enter the next slot.
or
Press this key.
Initial state for Programming Mode.
8 9
1 2
1
2
#
9 1
0 1
0
4 01
#
0 1
0
4 01
#