Siemens HiPath 1130 - Assigning an External Number to an Extension

Programming a Digital Trunk
123
Step by Step
Assigning an External Number to an
Extension
The external numbers registered for each slot (see
"MSN and Extension Assignment - Code 086") must be
assigned to extensions or Call Groups designated for
answering calls during a specified period of time.
Each extension can only be entered once. A distinctive
tone on the handset indicates an invalid entry.
In the default configuration there are no extensions
assigned to any slots.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the external number slot.
... Select a period of time:
= Day, incoming
= Day, outgoing
= Day, incoming, after a specified period of time.
= Night, incoming, after a specified period of time.
Enter the extensions or Call Groups (CG, HG or UCD -
up to 10 extensions per group. For example, 11/770,
780 or 790).
... Enter the next slot.
or
Press this key.
Initial state for Programming Mode.
Deleting an Extension Number
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the external number slot.
Press the key to remove it.
... Enter the next slot.
9 2
0 1
0
4 01
1 4
1
2
3
4
0 1
0
4 01
#
9 2
0 1
0
4 01
*
0 1
0
4 01