Siemens HiPath 1130 - Timer for Deactivating the Relay; External Ring for Activating the Relay

Relay and Sensor on the HiPath 1120
133
Step by Step
Timer for Deactivating the Relay
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the length of time (000 to 255) that the relay must
remain closed. One unit equals 0.5 seconds.
The default is "002" = 1 second.
Press this key.
Initial state for Programming Mode.
External Ring for Activating the Relay
This setting lets you use the relay to control a second
ring signal for an analog extension.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 12/102).
Initial state for Programming Mode.
7 3
0 0 0 2 5 5
#
If the closing time is set to "000," the relay will
remain active until it is manually deactivated.
0 7 1