Siemens HiPath 1130 - Data Transfer Speed; Digit Suppression in Call Detail Reports

Step by Step
Call Detail Report Manager
104
Data Transfer Speed
The system can be connected to a PC or printer with a
V.24 adapter to display or print the call detail report
(Æ page 102). The communication speed can be set to
ensure proper data transfer.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the code for the transmission (Baud) rate:
= 9600 baud
= 14400 baud
= 19200 baud
= 38400 baud
= 56000 baud (default)
= 57600 baud
= 115200 baud
= 128000 baud
= 256000 baud
Initial state for Programming Mode.
Digit Suppression in Call Detail Re-
ports
The last digits dialed in an external call can be
suppressed in the data output. These digits are
replaced by "?."
By default, no digit is suppressed.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Select the number of digits to be suppressed.
Initial state for Programming Mode.
2 0
1 9
1
2
3
4
5
6
7
8
9
2 1
0 9