Siemens HiPath 1130 - Modem Extension; MSN and Extension Assignment; External-To-External Transfer

Step by Step
Programming an Extension
72
Initial state for Programming Mode.
Modem Extension
This setting specifies the extension where the modem
is connected.
By default, no extension is configured.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 11/101).
Initial state for Programming Mode.
MSN and Extension Assignment
This setting assigns extensions to each MSN to be
transmitted to the outgoing calls destination.
In the default configuration there are no extensions
assigned to any slots.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 11/101).
or Select a period for operation:
= Day
= Night
... Enter the slot (001... 140) for the MSN.
Initial state for Programming Mode.
External-to-External Transfer
This feature allows a specified extension to transfer an
external call (incoming or outgoing) to another external
call.
Required: Programming Mode must be active (*95
31994).
0 8 5
0 8 6
1 2
1
2
0 1
0
4 01