Siemens HiPath 1130 - Activating;Deactivating the Timer for Outgoing External Calls; Second Attendant for MSN

Programming an Extension
71
Step by Step
Enter the code for programming.
Enter the extension number (e.g., 11/101).
Enter the length of time for the duration of external calls
for the specified extension (00000 to 17279 in 5-second
increments), where 00 = 0 seconds... 36 = 180 seconds
(default), etc.
Enter the next extension number
or
Press this key.
Initial state for Programming Mode.
Activating/Deactivating the timer for outgo-
ing external calls
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 11/101).
or Activate/Deactivate the timer for an outgoing external
call:
= To activate
= To deactivate (default)
Initial state for Programming Mode.
Second Attendant for MSN
This setting specifies a timeout after which a call will
start ringing at the extension set as Second Attendant
(see MSN and Extension Assignment on page 72).
The default configuration is set to 30 seconds.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot (001... 140) for the MSN.
... Enter the delay time (00 to 99 in 5-second increments)
where 00 = 0 seconds... 06 = 30 seconds (default), etc.
4 70
#
4 80
*
#
*
#
0 8 2
0 1
0
4 01
0 0 9 9